Fd rx7 gearbox into rx4
#1
New to the Club!
Thread Starter
Join Date: Jun 2022
Location: Tauranga
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
Fd rx7 gearbox into rx4
Hi there, has any one modifyed an rx7 Fd gearbox to fit an Rx4, I'm using fc Bell housing and tail shaft end to shorten gear box
#2
Full Member
iTrader: (1)
bellhousings have different length so better stick to the fd and use fd Pull type clutch, use a S5 Fc tail section and shorten shifter tower and youre good , if you insist on using an Fc bellhousing you will need a spacer(between trans and bellhousing if i remember correctly its either 10mm or 15mm) to give the proper input shaft position into the pilot bearing. custom trans mount will be needed either way for the rx4
Thread
Thread Starter
Forum
Replies
Last Post
zx1441
3rd Gen General Discussion
7
10-16-21 12:54 PM