303 wankel engine build
#1
Junior Member
Thread Starter
303 wankel engine build
Hello everyone, just join up on this site to show some of my sachs engine projects and maybe get some help and advice on these engines.
I was lucky to get some brand new sachs 303 engine parts, so will start collecting more parts to build the sachs 303 engine.
I'm having problems with attachments,get to 90% and stops ?
I was lucky to get some brand new sachs 303 engine parts, so will start collecting more parts to build the sachs 303 engine.
I'm having problems with attachments,get to 90% and stops ?
Last edited by Sachs Man; 04-19-19 at 06:32 AM.
The following users liked this post:
FEED AFFLUX v5 (04-27-19)
#3
roTAR needz fundZ
iTrader: (1)
Hello everyone, just join up on this site to show some of my sachs engine projects and maybe get some help and advice on these engines.
I was lucky to get some brand new sachs 303 engine parts, so will start collecting more parts to build the sachs 303 engine.
I'm having problems with attachments,get to 90% and stops ?
I was lucky to get some brand new sachs 303 engine parts, so will start collecting more parts to build the sachs 303 engine.
I'm having problems with attachments,get to 90% and stops ?
#6
Junior Member
Thread Starter
Been patiently waiting for parts to arrive from overseas, these parts arrive today from Dart motor sport in the UK. they fit the sachs 303 rotor. I notice the corner springs are a heavier gauge spring and only one spring for each corner of the rotor. With the sachs engines they use a lighter gauge springs and two springs for each corner of the rotor the convex sides must be touching to ensure maximum spring compression. I have save well over $200 from buying from Dart motor sport compared to the Us seller
Last edited by Sachs Man; 04-30-19 at 04:37 AM.
#7
Junior Member
Thread Starter
I have started a pre assembly on the engine, machine up some alignment dowel tubes and clean up the eccentric shaft.
Last edited by Sachs Man; 04-30-19 at 04:40 AM.
Trending Topics
#8
Junior Member
Thread Starter
Got some more work done on the engine, fitted all the seals on the rotor and assemble the engine. All good no issues, rebuilt the magneto unit with new parts and assembled.
#11
Junior Member
Thread Starter
#13
Junior Member
Thread Starter
Thread
Thread Starter
Forum
Replies
Last Post
felixwankel88
Old School and Other Rotary
14
02-16-24 03:20 PM
Templeton
Old School and Other Rotary
19
10-01-13 11:01 PM