is there any way to wire the 13b with the EFI? or is it nessisary to go to carb??

 

Where there's a will, there's a way. This one is carbed. https://www.rx7club.com/showthread.p...hreadid=285622 It's a B2000 by the way.

 

mine came with a carb on it so I put a holley with a S\C on it and will be done in 2-3 weeks and I will post photos when it is all done...

 

Looking for some more info! I am thinking of doing this swap with a 2600i. I want to use a turbo tranny and engine with an Atkins SC. I was wondering how the tranny and engine mounting was accomplished? Custom drive shaft? Did you use the stock tranny mount or a TII one? Many questions if you would....

THanks

 

the b2600i trani is a very strong trani and all you
would have to do is change the bell housing and
bolt up your 13b. engine mounts are the only real
job but from what i have heard its not that hard either.

matt

 

yes there is a way to use the EFI that came with the engine, you need the doner car the engine came out of, to get the complet wire harns, PCM/ECU, all the sensors,air flow meter, coils, so on, a good wiring diagram as a check list and what to do list, I all ready have all the parts to do this, O, oil cooler and trans is help full, All I need now is the truck, like a stright B2200/cab modle, and I'm ready to go

 

the 4wd one or the 2wd one?

 

either i believe will take the rx bell housing

matt

 

How the hell did I log in as someone else?!??!

 

you where dialing home at the same time some one els was and the Star Gate didn't know what to do so Capt Kirk your body was split in two and was sent off as SGT 1 & 1.1 to fight the peaple with eyes that glow

 

So I would use the 13b bell housing or the 2.6??

 

is the trans the key
i let go my 2200 trans
and im trying to put a TII 13b in a 2200 body
with a tII 5 speed
it seems long
and the engine is high and the trans is low
and the turbo is close to the frame

http://www.cooldudeproductions.com/B2200colorswap.jpg