Rotards doing rotarded things to rotaries III
gurgle gurgle gurgle 
I remember getting in my car and moving away from yours when I saw all that gas pouring out the carb, over your engine, down over your HOT EXHAUST and puddling on the ground.
Remember having to wait for the gas to stop shooting out the tailpipe before finally heading back down the mountain?
LOL... good times
Sometimes i wonder how we have lived so long

I remember getting in my car and moving away from yours when I saw all that gas pouring out the carb, over your engine, down over your HOT EXHAUST and puddling on the ground.

Remember having to wait for the gas to stop shooting out the tailpipe before finally heading back down the mountain?
LOL... good times
Sometimes i wonder how we have lived so long
Banned. I got OWNED!!!
iTrader: (52)
Joined: Mar 2009
Posts: 1,605
Likes: 0
From: Philomath Oregon.The five whole blocks of it!
whats fun to think about is that i was about three seconds away from starting it, before somthing deep down made me check under the car....Why, dont know? Just felt like i needed too, and thank god, no KABOOM!
i have ..but lookin for some 1 to install. 3 inch turbo bac ex haust will be here by monday ill let u now how she runs , i need shifter off my core for my kid . can i come get that ?if u havent got tranny swaped yet.10mm
You'll need more than a few new ponies to keep up with me
. But maybe we can map out a slightly more interesting route from salem down next time. Say south river to riverside then back on at ankeny? Or maybe take summit loop?
. But maybe we can map out a slightly more interesting route from salem down next time. Say south river to riverside then back on at ankeny? Or maybe take summit loop?
Thread Starter
Joined: Jun 2003
Posts: 1,154
Likes: 8
From: Mommy’s basement
let me get a new rear end and tranny. mine are both about toast. I cant really push it I cant afford to fix it right now. I have a new tranny, but I need to put part of my trans on to it, If I'm going through the trouble of dropping the tranny I want to put a new clutch, pilot bearing, throwout bearing. I think I can get away without the rear seal since my engine has low miles, but there cheap enough that I'll probably get that too. I'd also like to get a lightweight flywheel on there. So I can try and keep up with your T2.





