progress again
#1
progress again
i've been swamped with work since i started my new job, but i got a chance to get over to my car last weekend. mr. hammmy showed up to lend a hand and brought some manuals! manuals good!
anyhoo i got as far as wiring up the injectors, bolting on the UIM, and installing the distributor and airbox. to my surprise, the SE throttle cable installed onto the S4 throttle body without any problems. i tested the S3 and S4 TPSes with a multimeter, and they both measured identical ohm loads at zero and wide open throttle.
any recommendations on the intake ducting? i was thinking of just using the part of the S4 intake duct that attaches to the TB, and getting some ducting from lowes as a sort of g-fab setup. any other recommendations?
anyhoo i got as far as wiring up the injectors, bolting on the UIM, and installing the distributor and airbox. to my surprise, the SE throttle cable installed onto the S4 throttle body without any problems. i tested the S3 and S4 TPSes with a multimeter, and they both measured identical ohm loads at zero and wide open throttle.
any recommendations on the intake ducting? i was thinking of just using the part of the S4 intake duct that attaches to the TB, and getting some ducting from lowes as a sort of g-fab setup. any other recommendations?
Thread
Thread Starter
Forum
Replies
Last Post
Engine stand ready
New Member RX-7 Technical
11
09-11-15 08:12 AM