cr-rex

iTrader: (114)

Do you not have one at all? You don't need to do anything extra to put led bulbs in. If you get the hyperflash then you can put the resistors in place. Prettt sure you can get them at any parts store.

Narfle

iTrader: (16)

Yeah, just wanna get a second one to do up, so I can hot-swap it.

Pete_89T2

iTrader: (4)

If that's the case, the mod you need to do to kill the hyper-flash with the LEDs is reversible. Not quite a "hot swap" operation, as you'll need to grab a soldering iron, but easy enough. Reference Dale's write-up here, https://www.rx7club.com/3rd-generati...-943516/page3/ and then go to my post at #68-69. Instead of replacing the R1 resistor with a 1M ohm resistor as Dale suggested, I simply de-soldered one of its leads from the board and insulated it with some heat shrink. Same end result achieved with the LEDs, but it's a little easier to reverse if you ever have to.

Narfle

iTrader: (16)

Thanks team. Got one on the way. Will report back.