wiper motor replacement parking
03-02-13, 11:44 AM
#1
Junior Member
Thread Starter
Join Date: Oct 2012
Location: san antonio
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
wiper motor replacement parking
Hi all, this is Cargirl. I have a 84 RX7. Does anyone have any suggestions on fixing the parking position of the wiper blades after the replacement of the wiper blade motor. I replaced the motor, but I must of done something wrong. Do I have to take it all apart and move the arm attached to the motor to change the park position? Thanks.
03-03-13, 05:41 AM
#2
Senior Member
iTrader: (1)
Join Date: Aug 2010
Location: Southern Minnesota and Southern California
Posts: 340
Likes: 0
Received 0 Likes
on
0 Posts
You can just take the arm off and set it to the correct position. There is a cap covering the nut that holds the arm on the threaded position. Its a little early. I hope that makes sense. Good luck
03-03-13, 12:29 PM
#3
Junior Member
Thread Starter
Join Date: Oct 2012
Location: san antonio
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Hi All: Thanks for your response Clykins. I have replaced the wiper motor. This has changed the parking position of the wipers. I have moved the wiper blades many times. It just creates a situation wherein the wipers clean the hood of the vehicle. I was looking for information on which way to adjust the attachment on the new wiper motor so that I do not have to struggle with trial and error. Thanks.