Wheel Bearing Dust Caps
#1
Junior Member
Thread Starter
Join Date: May 2013
Location: Florida
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Wheel Bearing Dust Caps
I've looked online and the parts store can't seem to find out what size I need either. I've got a 1980 RX-7 that needs a new set of front wheel bearing dust caps. Does anybody know where I can order them online or at least what size they are? (I'm not sure if this is a part that comes in standardized sizes that manufacturers pick from.) Also, I'd appreciate the sizes for the rear dust caps for the '80-'85 years.
Thanks in advance.
Thanks in advance.
#2
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
I'm not familiar with the size,but I would get a caliper and measure the inside where the caps sits and then see if a regular parts store would carry them.
Another suggestion is go "used" and place a Wanting to Buy Ad up in the 1st Gen Parts section.
(I usually don't allow WTB parts but you were asking about size..)
Another suggestion is go "used" and place a Wanting to Buy Ad up in the 1st Gen Parts section.
(I usually don't allow WTB parts but you were asking about size..)
Thread
Thread Starter
Forum
Replies
Last Post