Well here is a few pics of what im talking about. got the motor out the other day and i was looking it over and found one of the water jackets was well chipped off.... Is there a way to fix this or is it ok to leave it that way. The motor ran fine before i pulled it out.

 

replace the iron. i was working on something to fix the issue but not anymore.

 

just replace the whole thing?

 

whole iron, yes.


eh screw it. if you are hard up to not replace the iron:

if you know a good welder it can be welded, run over the weld with epoxy and use a spare short apex seal to bridge it for additional support in case the weld ever breaks.

or

get a .015" stainless steel, form it into a ribbon that fits into the channel and weld the seam. sheet needs to be at minimum 30" long before trimming.

 

hmmmm where would i go about finding one? i guess ill search the forums