kelldog44

Okay so I have the engine out and am attempting to remove the trans from the engine. I thought it was as simple as remove the 5 bolts holding the bell housing to the engine and disconnect the plugs and it should pop right off. I've got it to pull back about an inch from the motor but its acting like its stuck on something. Do I just need to pull harder or did I miss something?

TheDarkSide

iTrader: (3)

http:// https://www.rx7club.com/3rd-...-video-256126/

RX7Zamboni

Unbolt the pressure plate from the flywheel and Then it will pull apart hade the same problem on my fd but the motor was still in the car

RX7Zamboni

Here is the rx7 manuel PDF file RotaryHeads.com - 3rd Gen RX-7 PDF Technical Manuals FD3S
This thing will be ur best friend

kelldog44

Came right off! thanks guys!

Sgtblue

iTrader: (16)

Couldn't get Darkside's link to work, but this one seems to be good....

At first it might seem complicated, but it gets easier every time you do it. .

Von Hayden

good to hear you got that sucker off