s5 irons on an s4 (FC)
#1
s5 irons on an s4 (FC)
The question is if I can run s5 irons on a stock s4 block without modification?
Simple question but I want to understand why or why you can't use them. My thinking is that the s5 irons are slightly thicker and reduce the chances of cracking so I'd like to use them on my build. However, I know that the s5 has a different harness therefore I want to retain the s4 housings and front plate. I also understand that the s5 rotors have a higher compression rate than the s4 rotors but I have 5 sets of s4 rotors so that's what I'll be using.
To recap:
S4 wiring harness
S4 injectors
S4 rotors
S4 housings
S4 front plate
S5 irons (all three)
Can this be done without modification?
Simple question but I want to understand why or why you can't use them. My thinking is that the s5 irons are slightly thicker and reduce the chances of cracking so I'd like to use them on my build. However, I know that the s5 has a different harness therefore I want to retain the s4 housings and front plate. I also understand that the s5 rotors have a higher compression rate than the s4 rotors but I have 5 sets of s4 rotors so that's what I'll be using.
To recap:
S4 wiring harness
S4 injectors
S4 rotors
S4 housings
S4 front plate
S5 irons (all three)
Can this be done without modification?
Thread
Thread Starter
Forum
Replies
Last Post
FührerTüner
2nd Generation Specific (1986-1992)
13
09-27-15 02:16 PM