aleksi94

Hey. Im new rotary owner and i build bridgeported rotary beast. Car started and running just fine. Rigth now i dont have datalogit and my manifold desing sucks and im not stressing my engine too much bcuz everything is new.

Just wanted some info which way i start to adjust my ignition and this split thing is new to me so it would be nice to know about it little bit more.

I tryed search with no results so i came here to ask ur guys advice.

Engine mods:
Bridgeported
turbo Holset Hx 52
Custom 4 inch exhaust
ultimate fuel system from rx7 store with 850/1680 injectors
autobanh 88 fmic
ignition stock with 4x ngk r625k-105
supra fuel pump
Power fc

Some safe numbers where i should stay in idle cruise and boost before i tune. I will be running low boost around 7-14 psi. Fuel im gonna be using is 98 Ron. Im new in tuning so if theres good article or place where i can learn more about ignition timing im willing to read just hit me up with good links. Rigth now i have power fcs base ignition map.

Thank you for help
Aleksi