Rally Prep
01-24-18, 11:33 AM
#1
Rally Prep
Once I find an FD chassis, I'm going to begin converting it to a rally/track car. Does this tentative plan sound reasonable?
- Learn to TIG weld, buy a welder
- media blast the chassis, get it immediately epoxy primed
- Build an FIA spec roll cage with my mechanical engineer brother
- Get it painted
- Make underbody protection with some high strength plastic
- Rally suspension
- Drop a rotary back in it
- Accusump
- Race seats/harness
- Make a custom data acquisition platform out of some Arduino's
Then it's off to the races!
Do these rotary motors need anything special to handle high Gs and lots of revs?
- Learn to TIG weld, buy a welder
- media blast the chassis, get it immediately epoxy primed
- Build an FIA spec roll cage with my mechanical engineer brother
- Get it painted
- Make underbody protection with some high strength plastic
- Rally suspension
- Drop a rotary back in it
- Accusump
- Race seats/harness
- Make a custom data acquisition platform out of some Arduino's
Then it's off to the races!
Do these rotary motors need anything special to handle high Gs and lots of revs?
Thread
Thread Starter
Forum
Replies
Last Post
tallbozo
1st Generation Specific (1979-1985)
13
06-05-07 10:48 AM