porting question
#1
Full Member
Thread Starter
Join Date: Feb 2010
Location: new jersey
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
porting question
so when you portout a 6 port what ports do u open up? primaries secondaries or auxillary? i cant seem to figure it out im looking into eithing doing as big a street port as possibl or a hand alf bridge or something its for a street car. i just cant seemto figure it out
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
ANY porting you do on the 6 port block will reduce low end torque. The 6 port blocks already have HUGE ports.
Limit your porting to the primary ports by moving them up a little. Don't move them out towards the rotor housing.
Move the exhaust ports up a few MM and widen them a few MM. Remove the diffuser.
Move the aux port out towards the rotor housing a little.
A good port template is the Mazdatrix 6 port template.
Limit your porting to the primary ports by moving them up a little. Don't move them out towards the rotor housing.
Move the exhaust ports up a few MM and widen them a few MM. Remove the diffuser.
Move the aux port out towards the rotor housing a little.
A good port template is the Mazdatrix 6 port template.
Thread
Thread Starter
Forum
Replies
Last Post