Parts fabrication Aluminum/fiberglass?
08-18-10, 02:30 PM
#1
Junior Member
Thread Starter
Join Date: Aug 2010
Location: Cincinnati, OH
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Parts fabrication Aluminum/fiberglass?
I'm planning on lightening up my 91 rx7 FC3C (convertible) considerably. I am wanting to go fiberglass route for low cost and it is lighter than carbon fiber and about 1/3 the price. I'm looking for a plane fiberglass or aluminum hood and trunk lid. I have found every other panel for the car but those.
I'm planning on dropping a front mounted intercooler in it and a TII S5 engine. That rules out having a top forced air scoop. I'm trying to find just a plane Jane OEM styled hood in either material.
Does anyone know of a fabricator for cars that works either of these materials? I know getting them custom fabbed would be sligthly pricey... but I'm sure it's not as much as a CF hood or trunk lid.
I'm planning on dropping a front mounted intercooler in it and a TII S5 engine. That rules out having a top forced air scoop. I'm trying to find just a plane Jane OEM styled hood in either material.
Does anyone know of a fabricator for cars that works either of these materials? I know getting them custom fabbed would be sligthly pricey... but I'm sure it's not as much as a CF hood or trunk lid.
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM
