Part Identification?
Thread Starter
Full Member
iTrader: (1)
Joined: Mar 2013
Posts: 166
Likes: 0
From: Granite Falls, WA
Part Identification?
Hey guys I was wondering what these two cannisters are? They look like they're part of my Vacuum system but the top one's cable that went to my throttle hasn't been connected since I bought the car about 3 weeks ago. I'm slowly cleaning up the mess left behind by the P.O. and the other P.O. who swapped the 13b+turbo into it.
Thanks
-Ghooble
Thanks
-Ghooble
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
The top one is your cruise control unit,that attaches to the throttle body by a cable.
The lower one is the Charcoal cannister for fuel and oil vapor...emission stuff..sort of.
The lower one is the Charcoal cannister for fuel and oil vapor...emission stuff..sort of.
Thread Starter
Full Member
iTrader: (1)
Joined: Mar 2013
Posts: 166
Likes: 0
From: Granite Falls, WA
So then is the bottom one unnecessary if we don't have to do emissions testing in my county? I run cat-less too. I'll probably remove the Cruise Control unit. Thank you so much
-Ghooble
-Ghooble
Joined: Sep 2005
Posts: 25,581
Likes: 136
From: Smiths Falls.(near Ottawa!.Mapquest IT!)
A tube from the gas tank runs to it to evaporate any fuel vapor in the tank.
IT also takes the oil vapor from the oil filler tube and center iron.
You can get around the Latter with a Catch can,but you would be "on your own" with the Fuel vapor aspect of it.
I will not voice any opinion on that.!
IT also takes the oil vapor from the oil filler tube and center iron.
You can get around the Latter with a Catch can,but you would be "on your own" with the Fuel vapor aspect of it.
I will not voice any opinion on that.!
Thread Starter
Full Member
iTrader: (1)
Joined: Mar 2013
Posts: 166
Likes: 0
From: Granite Falls, WA
A tube from the gas tank runs to it to evaporate any fuel vapor in the tank.
IT also takes the oil vapor from the oil filler tube and center iron.
You can get around the Latter with a Catch can,but you would be "on your own" with the Fuel vapor aspect of it.
I will not voice any opinion on that.!
IT also takes the oil vapor from the oil filler tube and center iron.
You can get around the Latter with a Catch can,but you would be "on your own" with the Fuel vapor aspect of it.
I will not voice any opinion on that.!
Thanks again good sir.-Ghooble
Thread
Thread Starter
Forum
Replies
Last Post
Heedlessone
Group Buy & Product Dev. FD RX-7
288
Sep 16, 2018 07:22 PM
driftfcbuckey
The Bad & Fugly Members
10
Dec 2, 2015 05:48 PM
KAL797
Test Area 51
0
Aug 11, 2015 03:47 PM