My clutch has been acting up recently, would have the pedal stick down to the ground when in neutral going into 1st or reverse. every other gear was fine when moving, then 1st into 2nd started sticking. By this point I had already know the clutch hydraulics were going out so had ordered a replacement slave cylinder and seals for the clutch master cylinder.

Fitted the new slave cylinder and waiting for the seals for the master cylinder and was wanting to know how I remove the old seals without damaging the master cylinder and fit new seals without damaging them. I tried searching but could only find guides for mk1 and mk 2 rx7's.

any help would be appreciated