When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Just looking for a few second opinions on these housings. I foolishly didn't do a compression test on the engine before I took it to bits.
I know the limit is around 2mm but most of the damage I've seen seems to be prolonged sections rather than little spikes like these are. One of them next to the exhaust port is 9mm though...
Thoughts? Should I scrap them and get new ones or are they okay for a first build?
Not a builder, but new/better housings are needed. You may need some other parts as well. Pretty deep grooves and flaking. And I'm not certain what was going on that would cause the seals to make chatter marks like that. The seal grooves on the rotors are out worn out of spec is a guess...maybe a builder will chime it.
