im in need of a loom!!
09-22-08, 04:24 AM
#1
Newbie
Thread Starter
Join Date: Sep 2008
Location: new zealand
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
im in need of a loom!!
i have a series 4 rx7 it goes hard. i also got a s5 engine to slap in it however to make the
new engine work i need a s5 loom and ecu does any one no where i can get one?
new engine work i need a s5 loom and ecu does any one no where i can get one?
09-22-08, 05:34 PM
#3
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
You can just use the keg.Then use the rest of the s4 Stuff on the engine,and wire the engine up as an s4...Oh,you need to Swap the front Cover.Or run Premix,as the S5 has an Electric Omp and the s4 is mechanical.
09-24-08, 05:51 PM
#6
keg is the bare block, omp is the oil metering pump. S4 used a mechanical pump and S5 used an electric pump. The OMP puts a small amount of oil in the combustion chamber to complete the seal and lubricate the engine. You can premix (put oil in the gas tank) and remove the OMP, this carries its own pros and cons.
Thread
Thread Starter
Forum
Replies
Last Post