I just can't grasp it, will these wheels fit?
#1
Wolf Pack!
Thread Starter
iTrader: (9)
Join Date: Jan 2011
Location: Fairfax Va
Posts: 150
Likes: 0
Received 0 Likes
on
0 Posts
I just can't grasp it, will these wheels fit?
http://www.1010tires.com/wheel.asp?w...90NUR635114G76
(Size)17" x 9" (Bolt Pattern)5/114.3 Offset(MM)63
I've read and re-read all the information I could find, downloaded the wheel and tire sizing spread sheet and I just can't seem to grasp it exactly.
How far can one go with offset (+/-) with a 9" wide wheel(or any inch wheel at matter)? Spread sheet says 44 Front, 31 Rear. Is that flexible and if so how would you go about doing that? I may be ignoring to truth because just I don't want to see it. So a more experienced opinion might just be what I need.
If that size will NOT fit which one of these will? The only part thats really confusing me are the Offset limits.
http://www.1010tires.com/wheel.asp?w...Matte+Gunmetal
Thank you for your time.
-Ed
(Size)17" x 9" (Bolt Pattern)5/114.3 Offset(MM)63
I've read and re-read all the information I could find, downloaded the wheel and tire sizing spread sheet and I just can't seem to grasp it exactly.
How far can one go with offset (+/-) with a 9" wide wheel(or any inch wheel at matter)? Spread sheet says 44 Front, 31 Rear. Is that flexible and if so how would you go about doing that? I may be ignoring to truth because just I don't want to see it. So a more experienced opinion might just be what I need.
If that size will NOT fit which one of these will? The only part thats really confusing me are the Offset limits.
http://www.1010tires.com/wheel.asp?w...Matte+Gunmetal
Thank you for your time.
-Ed
#2
Top Down, Boost Up
iTrader: (7)
For an FC:
Use this calculator to compare how much clearance you'll need with wider wheel of different offsets: http://www.1010tires.com/wheeloffsetcalculator.asp. Use a 7" +40 offset wheel for comparison, which is what's found on a stock TII.
I can tell you right now that a +63 offset 9" wheel would be hitting the front springs. You'll need to go out (lower offset) if you're going to be using extra wide rims. You should take some measurements, but if I had to give you a ball park estimate, I'd say +25 to +30 offset should be close. There's also a wheel fitment thread in the wheel/tire section. You'll probably have to pull fenders to get that width of wheel to fit up front.
Use this calculator to compare how much clearance you'll need with wider wheel of different offsets: http://www.1010tires.com/wheeloffsetcalculator.asp. Use a 7" +40 offset wheel for comparison, which is what's found on a stock TII.
I can tell you right now that a +63 offset 9" wheel would be hitting the front springs. You'll need to go out (lower offset) if you're going to be using extra wide rims. You should take some measurements, but if I had to give you a ball park estimate, I'd say +25 to +30 offset should be close. There's also a wheel fitment thread in the wheel/tire section. You'll probably have to pull fenders to get that width of wheel to fit up front.
Last edited by RotaryRocket88; 04-07-11 at 11:05 AM. Reason: specified FC since OP provided no details
Thread
Thread Starter
Forum
Replies
Last Post