harsh vibration in seat and shifter!
#1
Junior Member
Thread Starter
Join Date: Aug 2013
Location: Vernon BC, Canada
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
harsh vibration in seat and shifter!
Hi there I am the pround new owner of a 1988 rx7. I broke my front U-joint in half being silly. Now I got the joint fixed and the shaft balanced.Also, I replaced the tranny mounts and bracket, as well as got a tire balance. But I still have a harsh vibration in my seat and shifter. Im wondering if this is my rear u joint or maybe my back breaks are warped(they are in bad condition ) plz help I have no idea what this is! there is no tire play so I dont expect a wheel bearing. cheers
#2
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
did you do the install yourself after getting the shaft fixed?
My thinking is that the tail stock on the trans is screwed too,due to the Front U joint going.
My thinking is that the tail stock on the trans is screwed too,due to the Front U joint going.
#3
Junior Member
Thread Starter
Join Date: Aug 2013
Location: Vernon BC, Canada
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
I did put it back in my self, hmm it slid in no problem and there was no chipped or damaged teeth from what I could see. I have been driving it down make any gnar noises.
Thread
Thread Starter
Forum
Replies
Last Post