gsl se hard cold starts
Thread Starter
Junior Member
Joined: Jun 2009
Posts: 23
Likes: 0
From: Cowichan Valley, Vancouver Island, British Columbia, Canada
gsl se hard cold starts
I've purchased a gsl se with the original fuel injection intact. Although I have plenty of rotary experience, I've not worked with the FI before. The seller started the car by pouring a little fuel in one of the BAC tubes. That's one I haven't seen before. Any idea of what is would take to get it to start normally?
Once started, the car warmed up in the usual FI way, high idle for a few minutes then settled down and idled steady at around 800 rpm.
Thanks for any help.
Once started, the car warmed up in the usual FI way, high idle for a few minutes then settled down and idled steady at around 800 rpm.
Thanks for any help.
Thread Starter
Junior Member
Joined: Jun 2009
Posts: 23
Likes: 0
From: Cowichan Valley, Vancouver Island, British Columbia, Canada
Update - Happy Ending
A change of spark plugs, some new ignition wires and cleaning up of various circuit contacts resulted in the car flashing to life in less than a second and idling perfectly.
Maybe $375 wasn't too much to pay
A change of spark plugs, some new ignition wires and cleaning up of various circuit contacts resulted in the car flashing to life in less than a second and idling perfectly.
Maybe $375 wasn't too much to pay
Thread
Thread Starter
Forum
Replies
Last Post
sherff
Adaptronic Engine Mgmt - AUS
9
Feb 24, 2019 12:09 PM