FD driveshaft issue
04-14-12, 09:10 PM
#1
FD driveshaft issue
I have a 93 FD that has a JDM motor/tranny set in it. The driveshaft appears to have a 65mm bolt pattern, while the pumpkin appears to have a 70mm flange.
Anyone know if i can get either a driveshaft end to couple to the flange or just a flange to mate with the driveshaft?
I was also wondering which is the standard size for usdm driveshafts?
Thanks for any help
Anyone know if i can get either a driveshaft end to couple to the flange or just a flange to mate with the driveshaft?
I was also wondering which is the standard size for usdm driveshafts?
Thanks for any help
Thread
Thread Starter
Forum
Replies
Last Post
mulcryant
2nd Generation Specific (1986-1992)
10
09-09-15 05:24 PM
