FC3S suspension mount measurement request
05-04-17, 04:44 AM
#1
Can Post Only in New Member Section
Thread Starter
Join Date: May 2017
Location: New Zealand
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
FC3S suspension mount measurement request
Hi, I don't own an RX but hoping you nice folk will be able to help me out.
I have a JDM Starlet Glanza V, please hold your laughs until the end, and I'm looking at suspension cross compatibility (with a low-mid amount of bodging).
The FC3S has the right types of mounts all round, and I'd like to know how far off the actual dimensions are.
A rough coilover kit should deal to any height difference (RX springs are 20mm shorter each, but higher spring rates). RX coilovers are less then half the cost for Starlets in some cases.
Front top mounts - these are 4 bolts in a square.
Measurement request: bolt to bolt along an edge, and single bolt diameter (so I can calculate centres and PCD)
Front lower mounts - these are two through bolts.
Measurement request: bolt centres, single bolt diameter, inside distance between flanges. I'd calc centres from an outer edge of bolts measurement and bolt diameters.
Rear top mounts - these are two bolts in line w the strut.
Measurement request: bolt to bolt and single bolt diameter
Rear lower mounts - these are eyelets.
Measurement request: eyelet bushing width and diameter
Its a big ask but I'm hoping someone's got coilovers and verniers on their kitchen table and a few minutes to kill.
Cheers!
I have a JDM Starlet Glanza V, please hold your laughs until the end, and I'm looking at suspension cross compatibility (with a low-mid amount of bodging).
The FC3S has the right types of mounts all round, and I'd like to know how far off the actual dimensions are.
A rough coilover kit should deal to any height difference (RX springs are 20mm shorter each, but higher spring rates). RX coilovers are less then half the cost for Starlets in some cases.
Front top mounts - these are 4 bolts in a square.
Measurement request: bolt to bolt along an edge, and single bolt diameter (so I can calculate centres and PCD)
Front lower mounts - these are two through bolts.
Measurement request: bolt centres, single bolt diameter, inside distance between flanges. I'd calc centres from an outer edge of bolts measurement and bolt diameters.
Rear top mounts - these are two bolts in line w the strut.
Measurement request: bolt to bolt and single bolt diameter
Rear lower mounts - these are eyelets.
Measurement request: eyelet bushing width and diameter
Its a big ask but I'm hoping someone's got coilovers and verniers on their kitchen table and a few minutes to kill.
Cheers!
