Hey, I have a series 4 FC that has been stolen and recovered. The loom has been cut for the most part and the old owner has somewhat attempted to rewire to at least make the car run.
What are my options for a new loom, Is there anyone somewhere in the world that supplies new and/or tucked looms? I have had a google but to little avail and no one here in New Zealand does them.

 

Which harness was cut? Front engine harness?

 

The front harness to the lights etc is a bit burnt from an old downpipe set up and the harness from the ECU out to dash and engine has had the snip. The car runs but missing dash sensor lights and a few engine sensors.

 

I personally (depending on how bad the harnesses are) would try to source both harnesses on this forum. There's lots of part out threads. Check the classifieds.

I actually rebuilt my front headlight harness to delete my dash switches. It's not that difficult if you're comfortable reading wiring diagrams.

You can find the FSM and wiring diagrams here: Foxed.ca - Mazda RX-7 Manuals