emissions removal help
#1
Junior Member
Thread Starter
Join Date: Oct 2012
Location: the sticks
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
emissions removal help
I am not for sure what the line coming out of the tob of the rear iron was for. The one with a piece of blue tape on it. I think it is a coolant line that ran to the TB. Can I just block this off since I did the TB mods?
The big and the little nipple just above and below where the BAC went. What are they for and can they be blocked off. I am thinking that the little one is where I get my vaccum/boost for the pressure sensor and gauge.
And what went between the fuel injectors? Can I just put some JB Weld in the holes, or is there a block off plate for that spot?
Thanks for the help
The big and the little nipple just above and below where the BAC went. What are they for and can they be blocked off. I am thinking that the little one is where I get my vaccum/boost for the pressure sensor and gauge.
And what went between the fuel injectors? Can I just put some JB Weld in the holes, or is there a block off plate for that spot?
Thanks for the help
Thread
Thread Starter
Forum
Replies
Last Post