Custom taillight/headlight wiring?
#1
Junior Member
Thread Starter
Join Date: Jul 2016
Location: Central Massachusetts
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Custom taillight/headlight wiring?
Hey whatsup y'all! So I have a 1JZ-GTE swapped FC and the kid I bought the car off of cut the harness right at the firewall leaving nothing there.
I plan on wiring it all to a switch on my switch panel and turn on lights/wipers from there.
1. What color are the wires for headlights, side markers, turn signals and also wipers?
2. What are the color wires for the taillights? I know i the green one on the brake switch.
I plan on wiring it all to a switch on my switch panel and turn on lights/wipers from there.
1. What color are the wires for headlights, side markers, turn signals and also wipers?
2. What are the color wires for the taillights? I know i the green one on the brake switch.
#2
Retired Moderator, RIP
iTrader: (142)
Join Date: Sep 2005
Location: Smiths Falls.(near Ottawa!.Mapquest IT!)
Posts: 25,581
Likes: 0
Received 131 Likes
on
114 Posts
the wiper wires are incorporated into the engine harness(passenger side).You just take those wires and separate them,tape them up and re-connect..Done.
The Driver's side harness is attached to the inside fuse block..so that is a fun remove and replace..
Which harness was cut by the PO?
The Driver's side harness is attached to the inside fuse block..so that is a fun remove and replace..
Which harness was cut by the PO?
#3
Junior Member
Thread Starter
Join Date: Jul 2016
Location: Central Massachusetts
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
Basically the harness that goes into the drivers side firewall that connects to the fuse box was cut right off from what appears to be a angle grinder -.-“
Also the vehicle is a 91” FC haha
Also the vehicle is a 91” FC haha