bent bar...?????
#1
Newbie
Thread Starter
Join Date: Apr 2012
Location: Garland
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
bent bar...?????
I have a quick question. The bar behind the front bumper that goes across under the radiator where the oil cooler lines run across, how important is that bar? Because en-route of us pulling my fc home, it got bent, and i was wondering if it was important, because if its not necessary i was planning on cutting it off anyway.......
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
That's a fairly important structural member of the front end. Without it, the frame rails will want to move inward.
Straighten it out...
And don't use it to tow the car, it's not designed for that.
Straighten it out...
And don't use it to tow the car, it's not designed for that.
#3
Newbie
Thread Starter
Join Date: Apr 2012
Location: Garland
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Yea, i didnt realize that until it was too late..... so i guess just straighten it out the best i can. one of the welded ends was pulled off during that process, but i see that there are holes that are possibly for bolts. Could i just bolt it back to the frame, or would i have to re-weld it?
#5
Newbie
Thread Starter
Join Date: Apr 2012
Location: Garland
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Alright then. i hope it's not anything serious. i guess while the engine is out i'll tow is somewhere and have them check out the frame. I appreciate the input and help.
Thread
Thread Starter
Forum
Replies
Last Post
Devon300zx
2nd Generation Specific (1986-1992)
8
09-22-15 12:07 PM