"Add coolant" light came on today but temp gauge reads normal...

Reply Subscribe

Thread Tools

Search this Thread

Mar 18, 2012 | 07:21 PM

Richdip

Thread Starter

Junior Member

Joined: Mar 2012

Posts: 20

Likes: 0

From: Coachella valley

"Add coolant" light came on today but temp gauge reads normal...

how to preform a coolant flush and fill on my 88' fc? can some one tell me how to do this? please

Mar 18, 2012 | 08:16 PM

dwb87

This is my social media.

iTrader: (22)

Joined: Jan 2006

Posts: 2,744

Likes: 0

From: WA

FC3S Pro: Cooling

https://www.rx7club.com/showthread.p...hlight=Coolant

Mar 19, 2012 | 08:25 AM

Standing Z

Full Member

iTrader: (4)

Joined: Mar 2012

Posts: 60

Likes: 0

From: Milwaukee

If theres adequate levels of coolant in the radiator and the reservoir, most likely your sensor is faulty. Run an ohm meter on there and see if it's reading right, if not you know that's it. Good luck

Mar 19, 2012 | 04:17 PM

Richdip

Thread Starter

Junior Member

Joined: Mar 2012

Posts: 20

Likes: 0

From: Coachella valley

yes found out everything was fine just had to open the bleed pin for a bit and opened the radiator cap for a bit and reved the engine.

Mar 20, 2012 | 11:48 AM

Watase

Junior Member

Joined: May 2007

Posts: 20

Likes: 0

From: Vancouver

I had the same problem a couple years ago. In my situation the sensor itself was intermittent. The coolant was fine, but the damn thing would buzz every 5 minutes..

Very annoying.