AC compressor won't engage
#1
Junior Member
Thread Starter
Join Date: Mar 2011
Location: virginia
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
AC compressor won't engage
hey guys so i recharged the ac its holding pressure, but the clutch will not engage on its own so i by passed the switch and the clutch engages! but the haynes manual does not have any info on ac electrical circuits anybody have the schematics for the ac circuits i think it maybe a relay cause i can hear a click sound when i push in the ac switch on the dash but cant locate it any info would be helpful
#3
Junior Member
Thread Starter
Join Date: Mar 2011
Location: virginia
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
found the relay on the drivers fender replaced with good relay, did not solve problem. when looking over the system did not see any high or low pressure switches which is weird did not go to far into it today pretty busy will take a second look to locate and test circuits from relay and switch but have no schematics to go by! going to see if i can find any schematics online tonight
#4
Full Member
Which switch did you bypass, the pressure switch near the condenser? If so, verify that you have sufficient pressure for the pressure switch to be closed (usually 20psi or so), and if it isn't closing at that pressure then it is probably bad and needs to be replaced, which means discharging the system.
What are the pressures in the system when the switch is not working properly?
What are the pressures in the system when the switch is not working properly?
Thread
Thread Starter
Forum
Replies
Last Post