2nd gen 1986 rx7 not firing up
#1
Can Post Only in New Member Section
Thread Starter
Join Date: Jul 2017
Location: Colorado
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
2nd gen 1986 rx7 not firing up
my 1986 Mazda Rx7 is cranking but won't fire up. I'm new to this whole thing so I'm not quite sure what the problem could be. I have check fuel pump and spark plugs and wires.
#2
Full Member
iTrader: (1)
Is it all stock? I would do a compression test for starters. Go get a piston engine compression tester. Take out the schrader valve from the end of the hose. Do the test from the bottom plug holes. Have a buddy crank it over while you hold the compression gauge and you should see 3 even bumps on the gauge needle around 90 ish for each rotor. Its very easy to do and gives you a good idea of the engines health. There are lots of vids on youtube about this if you are unsure.