1984 RX7 Not Running
 

Hey guys, about a year ago I purchased a 1984 rx7. It didn’t have an engine in it, so I bought a parts car that contained a 12a. Fast forward a year, I have the 12a in my car and all connected. The problem is it won’t run for very long. I rebuilt the carburetor, installed a new fuel filter, pump, and fuel lines. It doesn’t seem to be getting gas very effectively even after all this work. It starts, runs for about 10 seconds and then dies. It seems like it can’t idle on its own either. What else could the problem be?

welcome to the board. :)

sounds like you're pretty close. see if this can get you over the top.

Troubleshooting a Nikki

let me apologize. i posted the wrong link yesterday.

Troubleshooting a Nikki

Fuel Not Getting Through the Carb

I would remove the fuel tank and then the pickup and inspect for hardened sediment in the tank. If the car sat for some time, the fuel tank may need to be professionally cleaned. You may be sucking up sediment and clogging the fuel filter or carburetor. Have you pulled the fuel filter to check and see if there was sediment in it?

link to your Your Thread in the Gen 1 Section