as the title says i was wondering where all the 3 and 4 rotors where in our region?

and if possible could you put your hp/ torque (at least estimate)

reason being is, lets just say im trying to persuade a friend or two that it is possilbe to do, by showing them the success stories in our area...so they do it...lol

 

4 rotors?

 

I don't know of any 4-rotors in this region. PFSupercars has done three 20B conversions: 2 FDs and an FC (mine). KD rotary has done some 3-rotor conversions, but I don't know how many. Acosta, in NJ, has/had a 20B-powered RX-8. As I understand it, they are having some business problems, so the status of the car is uncertain. There may be others. You could try asking in the 20B sub-forum under the Rotary Performance forum.

 

I heard of a Red 4 rotor FD out of NY, or NJ. I think it was a 20b at one time , now its a 4 rotor.

 

i dont know if that 4 rotor car is done yet, i know of the car you mean, and i know the 4 rotor was built for it, i just dont know if its running yet.

 

it used to be a 3 rotor now is a 4 rotor.....should be coming to my work by the end of feb....it might have been pushed back again.....we got 4 3 rotor cars at my work now..... https://www.rx7club.com/showthread.p...hlight=budfc3s

 

I just re-read your post and noted that you wanted hp figures. Mine has 427 hp and 478 lb/ft of torque.

 

Theres one in cincinnatti, rolled 364hp,on mustang (dream crusher) dyno I don't know why anyone would want one there rare expensive and need full front clip from cosmo or halitc and tuning to run ect ect. 13bre, street/race port halitec t66 ect and I'll run that boat ancor any day, and for a whole lot less money. unless its a drag car or show car whybother????build your 2 rotor right,2rotor bridge port twin t4 hybrids all clearanced balanced $8500.00 860hp at 8500rpm over 200mph on the salt flats back in the 80's