Looking for a place that does mandrel bends in NJ, any suggestions?

 

Mufflex in Trenton does mandrel bends IIRC.

 

Great, thats less than an hour away from me, by any chance do you have their number?

 

RAYCO at rout 18 the can bend 3" pipes

 

www.mufflex-performance.com
owner is denny and he is awesome. he worked on my RX7 two weeks ago.

 

Any idea what Rayco and Mufflex charge per bend? If it matters, its a 3" pipe.

 

mufflex charges by the hour...i think something like $45/hr...just a guess though...give them a call.

 

rayco, to the best of my knowledge, does not mandrel bend 3". they do crush bending, which will leave kinks.

 

Not bad, I'll give them a call when I get back.

 

Cheapest I have found is any Bus parts supply store. They have pipe up to 5in.

 

I too have gone to Muffflex. They cant do 2 3/4 in but 3 is fine. I had them do my turbo eclipse and did a great job. On the 7 there was a big mixup on what work I wanted and it cost me an extra 500 I didnt want to spend. Anyway explain exactly what you want and they will do a great job. leave no room for error or else you will end up with an all 304 stainless and TIG welded instead of aluminized and MIG welded. 500 dollar difference. Otherwise pretty good welders.