i'm looking for someone who can machine/pin my block and ensure everything's good before firing up the engine (then hopefully tune it afterwards). i dragged my 20b out of a shop who went bankrupt, and just worried that it may be incomplete, not suit for starting up, etc.

on a side note, i already had contacted a person i wanted to work with in the past, but i lost his contact info, so if you're that person, please contact me at anytime.

thanks all.

 

How far in west penn are you? PFS is in westernish maryland, about an hour west of baltimore. Ray has built a few three rotors and is a good tuner. Rx7store is in ohio also, dont know if either would be close enough, but look into them.

-Austin

 

RX7store.net is located in Ohio.

 

stick you might wanna bring it more east to KDR or JPR.....both are known to be reutable up here....and if you do let me know so we can go get some beers when you come by!

 

hey thanks guys. chris, thanks again. i think kdr rotary was the company i wanted to go with before. they seemed to be closed for the year, so i'll contact them in another week or so. he seemed to be very flexible with his time and my driving over with 20b in my trunk for a weekend job

once things are finalized, i'll pm you with the details. thanks all!

 

all i want is a ride in the beast!

 

actually meant sticks....but ill take a ride in yours too!....hell ill even pay for you next time at rotorjam and wont break your chops about parking the beemer with the fd's!