Hey guys, just finished pulling the motor from my car tonight. Next step is to get the flywheel cut. I don't have any of the special tools needed for the flywheel job though. Anyone local have the pilot bearing tool, flywheel holder tool, or a 300 ft/lb torque wrench for re-installation on the new motor (mine only goes to 150) I could borrow for a day?

Thanks!

 

Update: I have purchased all the tools necessary for the job including flywheel retainer tool, bigass 3/4" drive socket, 300 ft/lb torque wrench, and the disc alignment tool. Anyone local doing a clutch is welcomed to borrow as needed. I didn't get a pilot bearing removal tool though.

 

I could have let you borrow a couple of those things if I had seen this earlier. Sorry .