Chicago folks...
Well I made it home OK, not sure if I did it with 1 rotor or 2. The car would idle low at like 500rpm and pull only 10-12inHg vacuum, plus the engine shakes at idle. It struggle the most in vacuum and seems to do OK in boost, and boost build very quickly. On my way home I had to keep it in 4th gear most of the time so the rpm won't drop, the car shakes really bad if I give it too much gas below 3,000rpm or right at 0psi. Exhaust gas smell very rich but I didn't hear any backfire.
She's just sitting in the garage right now, I'll do a compression check tomorrow but all symptoms point towards the seal
She's just sitting in the garage right now, I'll do a compression check tomorrow but all symptoms point towards the seal
You have your Seven? Check JDMchicago. There are impromptu gatherings all over the place. Not much planned fromthe seven community right now... ALTHOUGH I may try to put something together again before winter hits...
You guys In for another get together?
You guys In for another get together?
bah, sorry I couldnt make it guys. I went to go pick up my car and while it was on the dyno the motor spun a bearing...
hopefully my motor was the only casualty of the day though.
now I just need like $5k for a proper rebuild... le sigh
hopefully my motor was the only casualty of the day though.
now I just need like $5k for a proper rebuild... le sigh
It won't start, I tried doing a compression check with a piston tester and it's not looking too good, tho the numbers are weird because I did the test twice on each rotor, and they are different each time. I pull the plugs and they are soak with oil, I ordered some new plugs and wires, I'll swap them out tomorrow and see if I can at least get her to start.
Thread
Thread Starter
Forum
Replies
Last Post
fastrx7man
3rd Generation Specific (1993-2002)
33
Sep 2, 2015 09:42 PM







