anyone
#3
Senior Member
Thread Starter
Join Date: Dec 2006
Location: Iowa
Posts: 602
Likes: 0
Received 0 Likes
on
0 Posts
13bt Swap help!
I am from waterloo, IA by cedar falls... yea i mean i know some people have done the swap in iowa to tur TURBO from the N/A and i mean i would actually pay someone to help me do it... i want to learn and oviously help do it. its just the process some of the threads through me off with the pin out ecus, run black wires from this solenoid and etc... i am a better hands on learner, and verbal than a reading... well if anyone can help that would be great.
#4
Alot Of Work!
iTrader: (1)
Join Date: Jul 2004
Location: Iowa
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
there is a tread in FAQ about repining your NA harness for Turbo engine sounds really easy just make sure you get tII engine tranny driveshaft basically whole drive line engine and trannys are very easy to remove / install. me and IANS have done it multiple times on both FCs and FBs as a matter of fact i am doing another right now
#5
Senior Member
Thread Starter
Join Date: Dec 2006
Location: Iowa
Posts: 602
Likes: 0
Received 0 Likes
on
0 Posts
Harness
Yea i am thinking i am going to just order a Jspec S4 turboII and get a drive shaft for it, unless i run into a rear end some where, will get a drive shaft to bolt to the TII tranny, and then order a USSPEC turbo harness, and computer that way i dont have to PIN anything out, just plug and play... and should be fairly easy from there... a bit of money but easy.
#7
Senior Member
Thread Starter
Join Date: Dec 2006
Location: Iowa
Posts: 602
Likes: 0
Received 0 Likes
on
0 Posts
Thanks
Thanks man you guys all been alot of help and i appreciate it. I mean i knew i was stepping into another world with rotary but you guys made it a fairly simple change thanks again...
i hope to get the motor like next week i may rebuild it just cause i dont know what that little japan kid may have done to it... l o l...
i hope to get the motor like next week i may rebuild it just cause i dont know what that little japan kid may have done to it... l o l...