Microtech wont rev!!
wont rev!!
Alright the first issue i had was the car not wanting to idle right, so i advanced the timing to 13 and it idled. now i go to rev it and the car leans out and want to die. i got the tps set to +05 and if i lower it the car dies.
heres my spec
S5 JDM 13BT streetport
720cc primary
1600cc secondarys
t04s p-trim 1.00 hotside .70 compressor
walbro 255 lph
i dont know what ecu info is needed but post do get it
Thanks
heres my spec
S5 JDM 13BT streetport
720cc primary
1600cc secondarys
t04s p-trim 1.00 hotside .70 compressor
walbro 255 lph
i dont know what ecu info is needed but post do get it
Thanks
Ive seen the map in your car.
And the only reason the car would lean out on that map is because your secondaries are not coming on?
Is this the first time you have the car running? or was it running before and then it died?
And the only reason the car would lean out on that map is because your secondaries are not coming on?
Is this the first time you have the car running? or was it running before and then it died?
this is the first time it been started. it somehow fixed itself and it started to rev.so i drove it around and then it started to act up.i would try to accel. and then it leans and starts popping. i let the car sit off for a bit and the started it and it ran fine. so i think im going to need a new map
Their is a problem with your car not with the map.
If it drives fine sometimes and not others.
YOU HAVE A PROBLEM.
I have replied to your pms with ways of finding problems but if you dont want to look for it. Then thats up to you.
If it drives fine sometimes and not others.
YOU HAVE A PROBLEM.
I have replied to your pms with ways of finding problems but if you dont want to look for it. Then thats up to you.
Thread
Thread Starter
Forum
Replies
Last Post
Prediict
2nd Generation Specific (1986-1992)
32
Nov 18, 2015 08:41 AM
LongDuck
1st Generation Specific (1979-1985)
12
Oct 7, 2015 08:12 PM





