Where is the best place to aquire all the plugs for the wiring loom? For example I need them for the CAS, water temp, air temp, injectors etc...
I am currently helping my brother put a series 5 13bt in his RX2 and we need all the plugs to fit the microtech.
Is it better to buy them all new from mazda or go and get them from a half cut?

Any advice would be appreciated.

Cheers

Daniel

 

Mazda doesn't sell them individually, but there are available work-alikes that you can use if you can't cut them off a junkyard harness or harness cut. For the injectors and the water temp sensor, MSD sells a pack of 8 square Bosch-style injector plugs. You may have to file down a ridge somewhere on the sensor body, but it's not a huge deal. For the air temp sensor, just use two female spade plug connectors. For the CAS, go to any electronics store and buy a generic 4-pin plug set and crimp some new pins on the wires.

Good luck!

Brandon
BR7 Racing

 

Thanks Brandon