Microtech Second hand lt10s
#1
Currently building my rx7
Thread Starter
Second hand lt10s
Hoping someone can help?
So I知 building my fc t2 and a microtech lt10s is up for sale with ignition module and digital dash
I知 thinking it will be perfect for my project but the ecu came from an FD, my understanding is microtechs where engine specific when first purchased.
So my actual question is will it run my Fc with the obvious plug/wiring mods?
pretty new to the electrics and ecus so any guidance would be very much appreciated.
So I知 building my fc t2 and a microtech lt10s is up for sale with ignition module and digital dash
I知 thinking it will be perfect for my project but the ecu came from an FD, my understanding is microtechs where engine specific when first purchased.
So my actual question is will it run my Fc with the obvious plug/wiring mods?
pretty new to the electrics and ecus so any guidance would be very much appreciated.
#3
Currently building my rx7
Thread Starter
If that was the case I’d pay the extra and buy a new adaptonic direct fit unit.
buy the time I’ve bought the unit paid for delivery and return and the hours taken it doesn’t weigh up.
theres 100% a difference with CAS, Not sure on anything else.
whole idea Might be a lost cause.
buy the time I’ve bought the unit paid for delivery and return and the hours taken it doesn’t weigh up.
theres 100% a difference with CAS, Not sure on anything else.
whole idea Might be a lost cause.
Thread
Thread Starter
Forum
Replies
Last Post
FC3S.USD
2nd Generation Specific (1986-1992)
22
11-22-03 05:49 PM