Microtech rx72c Why do I need to send the Microtech back?
#1
Full Member
Thread Starter
Join Date: May 2007
Location: knoxville TN
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
rx72c Why do I need to send the Microtech back?
rx72c Says because I have saved a blank map over the org map that none of the maps I hand type in will work.
I believe him because of the million helpful post I have read from him but I Just want to know why before I put this project on hold.
I have typed in one of the maps rx72c has posted in the past and after few adjustments my car has started and starts every time with perfect idle.
I can drive it a little but the wide band in load dances some what crazy and i believe it is because my microtech is not adjusting its timing while in load wot and in boost.
I set static timing to 5
when i try to set my TIMMAX to anything above 5 it automatically adjusts my timing to the TIMMAX timing.
So in all of this I was wondering do I need to send in my microtech and get them to reprogram it and if so why? does it have to do with this timing issue?
I believe him because of the million helpful post I have read from him but I Just want to know why before I put this project on hold.
I have typed in one of the maps rx72c has posted in the past and after few adjustments my car has started and starts every time with perfect idle.
I can drive it a little but the wide band in load dances some what crazy and i believe it is because my microtech is not adjusting its timing while in load wot and in boost.
I set static timing to 5
when i try to set my TIMMAX to anything above 5 it automatically adjusts my timing to the TIMMAX timing.
So in all of this I was wondering do I need to send in my microtech and get them to reprogram it and if so why? does it have to do with this timing issue?
Thread
Thread Starter
Forum
Replies
Last Post
Frisky Arab
2nd Generation Specific (1986-1992)
13
08-18-15 05:30 PM