Microtech Microtech trouble
#1
big boost baby
Thread Starter
Join Date: Jun 2003
Location: Okinawa, Japan
Posts: 269
Likes: 0
Received 0 Likes
on
0 Posts
Microtech trouble
Today my car died idling in my driveway, the handset displays like 10 black squares when the ignition is on. It usually displays like Microtech Program 13B-T ver. 2.0 blah blah. the ECU is the older Microtech Digi 2 plus.
Does anyone know what could be wrong? or has old age settled in, and I need a new ECU?
I bought this car back in september and dont know much about microtechs, I've read the manual but thats about it. Can anyone one offer and troubleshooting advice or procedures?
all mods in sig
Does anyone know what could be wrong? or has old age settled in, and I need a new ECU?
I bought this car back in september and dont know much about microtechs, I've read the manual but thats about it. Can anyone one offer and troubleshooting advice or procedures?
all mods in sig
#2
Senior Member
iTrader: (2)
Join Date: Oct 2003
Location: Pensacola, FL
Posts: 327
Likes: 0
Received 0 Likes
on
0 Posts
I have seen the handsets do this on the LT8 if there is a short somewhere. I.E. on an LTX8 the tach output was touching one of the coil signals and it caused this. I would say check your wiring first.
Thread
Thread Starter
Forum
Replies
Last Post
FC3S Timmy
2nd Generation Specific (1986-1992)
16
10-03-15 01:08 AM
Red-Dragon_Akuma
New Member RX-7 Technical
11
09-28-15 06:09 AM