Hey i been snooping around in here and have some quick question.

Well I have decided to go with the LTX8S and was wondering how hard it is to wire in.

I have a 88 GXL, with S5 na motor and putting on the turbo II parts to turbo it.

Also how hard is it to tune?

What all do i need to install it in my car.

 

How hard it is depends on how proficient you are at following the wiring diagram/instructions. It's good to at least know how to solder & heat-shrink. You should be able to just go through the manual and figure out how to set-up everything. Make sure you go through the manual a couple times and be sure you understand what it says though. The LTX8S should come with everything you need to succesfully install and run the car. Now's a good time to get new electrical connectors though ..... Otherwise you will have to re-use the ones from your existing wiring harness.

 

Where can u get new electrical connectors? i sold my old harness without pulling those off? and now every shop i ask and i showed them the picture and they have no idea what i am talking about...

 

Ok it doesn't seem like it will be too hard.

 

I think you can download the manual and take a look at the wiring diagram. Trust me when I say, it's a peace of cake.

www.microtechefi.com