Microtech LTX8, been perfect for 5yrs,then?
#1
Rotary Enthusiast
Thread Starter
LTX8, been perfect for 5yrs,then?
my LTX8 been runnin great for so long i forgot about it.
then no warning or change of anything it shows on wideband very lean when it used to go full rich ,like 10.5-10.9.
seems as tho the secondaries aint comin on, w/b shows 14.5 as boost comes up, so i been stayin out of boost ,till i get it straight. no power ethier.
Question;; where to start first?
stage is at 3000rpm , 5" vacuum, and you could feel secs. come on, w/b would show it BUT not workin now. just goes lean.
then no warning or change of anything it shows on wideband very lean when it used to go full rich ,like 10.5-10.9.
seems as tho the secondaries aint comin on, w/b shows 14.5 as boost comes up, so i been stayin out of boost ,till i get it straight. no power ethier.
Question;; where to start first?
stage is at 3000rpm , 5" vacuum, and you could feel secs. come on, w/b would show it BUT not workin now. just goes lean.
#2
talking head
set it to cyl= 0 in screen 31 config ( test mode ) ,, listen with a screwdriver handle in your ear that all injectors click,, and that all leads fire
then if OK
fuel pump static pressure test , pump volts check and dead headed ( max ) pressure check ,, change the fuel filter,, service the injectors
then if OK
fuel pump static pressure test , pump volts check and dead headed ( max ) pressure check ,, change the fuel filter,, service the injectors
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
joel(PA)
Group Buy & Product Dev. FD RX-7
8
10-04-15 06:07 PM