Microtech LT-8s Fuel Relay Wiring
03-01-06, 01:35 AM
#1
Damn Right It's Me
Thread Starter
iTrader: (1)
Join Date: Jan 2003
Location: Chino Hills, Cali
Posts: 1,331
Likes: 0
Received 0 Likes
on
0 Posts
LT-8s Fuel Relay Wiring
I was lookin at the diagram and am not to clean on how to wire up the fuel relay. Can i wire it to the relay on the steering column or should i use the relay that came with the set? Also wheres a good place to wire in the pink ign on wire?
Anyone have any pics?
Anyone have any pics?
03-01-06, 09:20 AM
#2
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Generally I run new wires to the fuel pump directly from the battery or 12V distrobution block. The stock relay gets removed/ignored.
As for IGN+, I always pull from the black/yellow wire at the trailing coil since the harness has to go in that direction anyway.
As for IGN+, I always pull from the black/yellow wire at the trailing coil since the harness has to go in that direction anyway.
03-03-06, 10:23 AM
#4
Engine, Not Motor
iTrader: (1)
Join Date: Feb 2001
Location: London, Ontario, Canada
Posts: 29,789
Likes: 0
Received 108 Likes
on
91 Posts
Generally I run a 12 gauge ground and power wire right to the pump.
For the wipers, I just chop that off the existing harness and rewrap. Rewiring is not a big issue but finding the harness plug on the interior end is.
For the wipers, I just chop that off the existing harness and rewrap. Rewiring is not a big issue but finding the harness plug on the interior end is.
Thread
Thread Starter
Forum
Replies
Last Post
streetlegal?
New Member RX-7 Technical
13
03-17-22 02:46 PM
The Shaolin
2nd Generation Specific (1986-1992)
9
09-14-15 07:50 PM
befarrer
Microtech
3
08-22-15 05:52 PM