Microtech LT 4 question
#1
LT 4 question
i have one problem right now on my harness of my LT-4, it say on the diagram that teres should be a white cable that is for the tach signal, but the harness have marked that is for auxiliary output, im confuse right now about it so can somebody can help me a little? ill apreciate it thanks
#2
Rotary Enthusiast
the white wire on the LT4 is for the ign input from the neg side of the leading coil,
have a look in the manual for the pinouts of the ecu and make sure it is in the correct spot
dale
have a look in the manual for the pinouts of the ecu and make sure it is in the correct spot
dale
Thread
Thread Starter
Forum
Replies
Last Post
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM