Microtech Idle quality with 1200cc injectors as primary?
#1
Rotary Enthusiast
Thread Starter
Join Date: Dec 2002
Location: Darwin, NT, Australia
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
Idle quality with 1200cc injectors as primary?
As per the title, any body done this before? 1200cc injectors as primaries?
If so, how was the idle quality?
If so, how was the idle quality?
#3
Rotary Enthusiast
Thread Starter
Join Date: Dec 2002
Location: Darwin, NT, Australia
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
Exactly what I wanted to hear! great. two 1200cc comming up for me then.
------
Slight off topic here.. buuut, 10sec_rx7, your putting a top loader in your rx aren't you?
I'm considering doing this to mine, how are you doing it? getting an adaptor plate between an Rx bell housing and the toploader GB?
What I was wondering today was about the input shaft of the top loader, does it sit into the standard spigot bearing?
------
Slight off topic here.. buuut, 10sec_rx7, your putting a top loader in your rx aren't you?
I'm considering doing this to mine, how are you doing it? getting an adaptor plate between an Rx bell housing and the toploader GB?
What I was wondering today was about the input shaft of the top loader, does it sit into the standard spigot bearing?
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
imitek
3rd Generation Specific (1993-2002)
9
08-28-15 05:28 PM
CaptainKRM
2nd Generation Specific (1986-1992)
14
08-26-15 09:52 PM