Microtech Idle map query
#1
Rotary Enthusiast
Thread Starter
Idle map query
I have an odd looking idle map.. It was programmed like this in normal mode. as I seem to recall I was told it was shaped like this for the injector staging? I question if the map should now look like this in matrix mode or should it be at a set value from 2psi onwards like the basemap would suggest? I gather you are never going to get into this area and unlikely to get partway into it from the 1000rpm line too.. so maybe the values don't matter at all? Nevertheless would like some feedback please.
Thank you
https://cimg3.ibsrv.net/gimg/www.rx7...10018ecd41.jpg
Thank you
https://cimg3.ibsrv.net/gimg/www.rx7...10018ecd41.jpg
#2
Senior Member
iTrader: (1)
From memory the manual states that the values above 0 mmHg are only used when you have an auxiliary injection setup and enabled ECU (which is special order setting). So on normal off the shelve ecus those settings do not do anything. So for most people only the 24-12mmhg idle cells will have any real effect as you would be idling and pulling vacuum in that range.
Thread
Thread Starter
Forum
Replies
Last Post