Microtech I can't get the car started!
#1
Rotary Freak
Thread Starter
iTrader: (3)
Join Date: Feb 2002
Location: MN
Posts: 1,697
Likes: 0
Received 0 Likes
on
0 Posts
I can't get the car started!
I already tried to ask this quesion, but here goes again...
The car just keeps flooding out, and fouling the plugs. Its just will not fire up no matter what adjustments I make to the Crank and Idle maps.
I have an S5 TII, with 550 primaries and 720 secondaries. Stock fuel pump until the fpr comes in, then I will install the Walbro.
This car already ran with 4x550's, but then I had a "tuner" mess with the maps. Since then, I upgraded the secondarys to the 720's and now the car just will not start!?!?!?!
I need someone to re-check the base map values that Silverrotor posted up in the Sticky thread. Please check all the values that are associated with start up...i.e. Base, Crank, Idle, Water temp, timing, etc...
I am so friggin frustrated! The car ran with the base map, but now that I tried to reset the "tuned" maps back to the base maps, the car will not start anymore.
-a
The car just keeps flooding out, and fouling the plugs. Its just will not fire up no matter what adjustments I make to the Crank and Idle maps.
I have an S5 TII, with 550 primaries and 720 secondaries. Stock fuel pump until the fpr comes in, then I will install the Walbro.
This car already ran with 4x550's, but then I had a "tuner" mess with the maps. Since then, I upgraded the secondarys to the 720's and now the car just will not start!?!?!?!
I need someone to re-check the base map values that Silverrotor posted up in the Sticky thread. Please check all the values that are associated with start up...i.e. Base, Crank, Idle, Water temp, timing, etc...
I am so friggin frustrated! The car ran with the base map, but now that I tried to reset the "tuned" maps back to the base maps, the car will not start anymore.
-a
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
09-05-15 10:23 AM